DPF Regenerator & Flush Fluid – a professional set of tools for
gentle cleaning and restoring the efficiency of diesel particulate
filters (DPF) without dismantling them. Suitable for all diesel engines,
both naturally aspirated and turbocharged, equipped with these systems.
Applicable for diesel engines equipped and not equipped with automatic
regeneration systems for diesel particulate filters. Suitable for all
DPF’s. The product is applied to the particulate filter using a sprayer
with a compressor.
– 9995 DPF Regenerator
starts the process of regeneration of the particulate filter. Promotes
complete burning of the accumulated soot, loosening it and acting as a
combustion catalyst. Dissolves and removes unburned dirt from the pores
of the particulate filter;
– Especially effective for vehicles operating in urban mode and in the cold season;
– Restores the full capacity of the particulate filter, and the 9996
DPF Flush Fluid washes out all the dissolved residues of the 9995 DPF
– Restores the original engine power by reducing the hydrodynamic resistance of the filter. Save fuel;
– Neutral low-ash formula. It evaporates without a trace and is removed from the filter.
– Extends the service life of the particulate filter and reduces the
cost of operating the car. Regular use may eliminate the need to replace
the DPF altogether;
– Reduces the toxicity of exhaust gases.
Stage with the use of DPF Regenerator 9995: Stop the engine. Cool the
diesel particulate filter to less than 40 °C. Pour the entire amount of
the product into the spray container. Remove one of the particulate
filter sensors (pressure or temperature). Insert the spray gun into the
orifice. Spray the entire volume of the product in the particulate
filter at a pressure of 4 BAR. Leave to act for 20 minutes. Replace the
sensor. Place the container under the exhaust pipe to collect dirt. Turn
on the engine and let it run at high speed (approximately 3000 rpm) for
5 minutes, while the exhaust pipe may leak dirty black liquid.
Stop the engine. Cool the diesel particulate filter to less than 40 °C.
2. Stage with application of washing liquid 9996 DPF Flush Fluid: Pour
the entire amount of the product into the spray container. Remove one of
the particulate filter sensors (pressure or temperature). Insert the
spray gun into the orifice. Spray the entire volume of the product in
the direction of the particulate filter at a pressure of 4 BAR. Leave to
act for 1-2 minutes. Insert the sensor into place. Turn on the engine
and let it run at 2000 – 2500 rpm for 5 to 15 minutes until the product
completely evaporates from the filter. During the cleaning process, foam
flakes may escape from the exhaust pipe. Stopping the foam output
indicates complete evaporation of the product.
is complete, you need to drive for 20-30 minutes on a flat road with an
engine speed of about 3000 rpm (it is allowed to let the engine idle for
20-30 minutes with a warm-up to the operating temperature). After that,
for the best effect, start the process of forced (manual) regeneration
of the particulate filter in accordance with the instructions of the car
To keep the particulate filter clean, use the 9994 MANNOL DPF Filter Cleaner in the future between service periods.